Den fullständiga citerade informationen nedan ger mycket mer information. Det enkla svaret:
Beroende på vilken produktionsmetod som används används antingen salt (förmodligen mejerisalt) eller saltuppslamning till smöret vid processen i processen när smöret och kärnmjölken har separerats före det slutliga arbetssteget, vilket också hjälper till att distribuera saltet.
Från Hur produkter görs :
Butter Manufacture Preparation
1 For many years the major creameries for butter manufacturing were located in the states of the Eastern seaboard, but the flourishing of a more industrialized agriculture in the Midwest led to the predominance of butter-making facilities there. The modern butter-making process begins when fresh cow's milk from dairy farms is brought into the facility. The product is inspected, classified into different groups according to its adjudged quality, and then filtered to remove impurities. Then the milk is separated by means of centrifugal force. It is pumped into a large, cylindrical, vertical rotator device. When turned on, this rotator spins the liquid until the cream rises to the top. The cream is then fed into large stainless steel vats and heated to 180°F (82°C) for about 30 minutes in the pasteurization process to remove any lingering bacteria. The pasteurized cream is then left to cool.
Churning
2 The cream is placed in a large, mechanical churn usually made of aluminum. Some of these industrial-sized churns can make 1,500-5,000 pounds (681-2270 kg) of butter at a time. When the churn is activated, it tumbles the cream, much like the motion of a clothes dryer, while a worker watches the process through a small glass window on the churn. After about 45 minutes, small granules of butter begin to form, and the butter and buttermilk are separated. Salt is added, and the mixture is churned further. When this process is completed, a stainless steel mobile device sometimes called a "boat" is placed adjacent to the opening of the mechanical churn. The door of the churn is opened, and the butter begins to spill out into the boat; activating the churn removes the rest. It is then wrapped into 64-pound (29 kg) cartons and sent to the distributor. There, the butter is repackaged for consumer and food-service industry use.
(Betona min.)
Det finns också en bra artikel (med ett diagram) på WebExhibits .
Även från University of Guelph .
Salt is used to improve the flavour and the shelf-life, as it acts as a preservative. If the butter is to be salted, salt (1-3%) is spread over its surface, in the case of batch production. In the continuous buttermaker, a salt slurry is added to the butter. The salt is all dissolved in the aqueous phase, so the effective salt concentration is approximately 10% in the water.
After salting, the butter must be worked vigorously to ensure even distribution of the salt. The working of the butter also influences the characteristics by which the product is judged - aroma, taste, keeping quality, appearance and colour. Working is required to obtain a homogenous blend of butter granules, water and salt. During working, fat moves from globular to free fat. Water droplets decrease in size during working and should not be visible in properly worked butter. Overworked butter will be too brittle or greasy depending on whether the fat is hard or soft. Some water may be added to standardize the moisture content. Precise control of composition is essential for maximum yield.
(Återigen betonar min.)